[Linuxha-users] Problems encountered during the linuxha.net installation on Centos

[Manoj Mathew]

Hi,
I have installed linuxha.net using tarp package manager.The installation 
went fine .The preliminary tests also went fine.But I am facing problems 
during testing Physical node failure tests.

1) The moment I power off using the power off button of one of the 
cluster systems. clstat starts showing that the cluster is not running. 
but all applications are running.
And when the system comes up I try to do the clform --join  which says 
that both clusters are down.
2) If I use the "shutdown now" command to switch of the cluster system 
then clstat gives the correct information as cluster is running and  the 
cluster node is in down state. But the moment the other node powers on 
,the clstat command again shows that the cluster is not running.

3) How to start linuxha.net on bootup automatically.
4) how to start sync up once one node comes up

Regards
Manoj Mathew




#-------------------------Vigorsoft Disclaimer-------------------------#
 Privileged / confidential information may be contained in this message If you are not the addressee indicated in this message or you are  not associated with this subject, you may not copy or send this message to anyone. In such case you should destroy this message and kindly notifythe sender in reply e-mail.Although this mail has been scanned for the presence of possible computer viruses prior to dispatch , we cannot be held responsible for any viruses or other material transmitted  as a part of this email without our knowledge.
#----------------------------------------------------------------------#